SincpacC3D
General Information
Command Summary
DLEnabled
|
SincpacC3D
General Information
Command Summary
DLEnabled |
Description
The DLEnabled command enables or disables the automatic updating of Dynamic Links in the drawing.
Usage
Type DLEnabled at the command line. You will then be prompted for the new setting for Dynamic Links, enabled or disabled. This setting is remembered for each drawing.
When Dynamic Links are enabled, they will automatically refresh as-needed. When they are disabled, you must manually update them using the DLRefresh command.
See Also
Creates linked PVIs from one Profile to one or two other Profiles; particularly useful for creating linked center, left, and right profiles for Three-Line Profiles.
Manages dynamic links between Cogo Points and other Civil-3D entities. This allows the elevations of Cogo Points to change dynamically whenever the "master" object changes. Similarly, the description may be set to display the Station/Offset of the point, and the Station/Offset will also dynamically respond to changes in the model. The "master" object may be a Surface, a Profile, an Alignment, or a linear entity such as a Feature Line, Survey Figure, Polyline, or 3D-Polyline.
Manages dynamic links between Profile PVIs and other Civil-3D entities. This allows the elevations of PVIs to change dynamically whenever the "master" object changes. The "master" object may be a Surface, another Profile, or an adjacent PVI on the same Profile.
Refreshes all Dynamic Links in the drawing that are known to be out-of-date.
Refreshes all Dynamic Links in the drawing.
Refreshes all Dynamic Links attached to selected objects.
