Video created 21 June 2009

Dynamic Cut/Fill Table

The video below demonstrates how to use the Sincpac C3D Dynamic Point Links to create a Point Table that contains a dynamic Cut/Fill listing of the points. In this demonstration, the Cut/Fill is calculated between the Cogo Point elevation and a Surface elevation.

The tasks illustrated in this demonstration require the Power Module of the Sincpac C3D, and may be performed in either Civil 3D 2009 or later. Since UDP access is limited in Civil 3D 2008, these tasks cannot be performed in Civil 3D 2008.

(Run time: 6 min 36 sec)