Description

The PtInv command displays an inverse between two CogoPoints. The inverse contains the Horizontal and Slope distances, the bearing, the slope and grade, and the Delta X, Delta Y, and Delta Z values between the points. It can also maintain a running total of successive distances, adding the value of each measurement to the running total.

The PoInv command has three different modes of operation:

• Single: Used to measure single segments; the start point and end point must be selected for each segment.
• Continuous: The first selection is the start point. After that, each selection is the endpoint for the current segment, and the start point for the next segment.
• Multiple: Used to measure multiple distances, all from the same base point. The first selection is used as the base point, then all successive selections are measured from that base point. The "Basepoint" keyword may be used to select a different base point.

The "Single", "Continuous", and "Multiple" keywords may be used to switch between the three modes at any time.

Usage

Type PoInv at the command line. You will be prompted to select two CogoPoints in the drawing. You will then see output similar to the following:

The values in the output are:

• HD: Horizontal Distance
• SD: Slope Distance
• Bear: Bearing between points
• Slope between points (1:n or n:1) in run:rise format
• Grade between points (percentage)
• E1, E2 The elevation (Z value) of each selected point
• dX, dY, dZ Delta X, Delta Y, Delta Z

The precision for the distance, slope/grade, and elevation values may be configured from the OPTIONS Tab. These settings may optionally be configured so that they are remembered on a per-drawing basis, in order configure different drawings to have different precisions. When using per-drawing settings, you may configure the settings in your drawing templates, to control the settings in newly-created drawings. Otherwise, newly-created drawings will take on the last-selected settings.

The values in square braces are running totals. The "Reset" keyword may be used to reset these values at any time.

After starting the command, continue selecting points in response to the prompts. You may also key in a Cogo Point number, instead of selecting a point on-screen. The "Single", "Continuous", and "Multiple" keywords may be used to switch between the three modes. To cancel the command, right-click or hit the ESC key.

See Also

PtInv

Inverse between picked points.

FindPt

Find and Replace text in the Raw Description for points.

FreePt

Displays a list of available point numbers in the command window.

MovePoints

Move points in the drawing. Points are only moved horizontally, with no datum adjustment, and may be selected by Point Group.

NextPt

Set the next point number for point creation.

PGAddRemovePoints

Add and/or remove selected Civil-3D Points to/from one or more existing Point Groups.

Pt3d

Manually create points with a variety of options, including getting the elevation from the pick point.

PtAng

Displays the angle formed by three points. The angle dimension is displayed as an interior angle, an exterior angle, and a deflection angle.

PtArc

Displays the arc distance, radius, and delta (central) angle of the arc segment defined by picking three points. Points may also be specified by keying in point numbers at the prompt.

RotateMarkers

Rotate Civil-3D Point Markers.

RotatePoints

Rotate Civil-3D Point locations, with an option to select by point group.

UsedPt

Displays a list of used point numbers in the command window.

ZoomPt

Zoom to a Cogo Point by typing the Point Name or Number in the command window.