SincpacC3D General Information Command Summary Quux Software



Note - Only available in Sincpac-C3D versions 3.0 and newer

The SPAdjustPipeSlopes allows the user to set the slopes of connected pipes to all be the same slope, as set in the command's settings.


Type SPAdjustPipeSlopes at the command line or select it from the Sincpac2 Ribbon Tab, Tools Panel, Pipes drop down. You will be prompted to select the Pipe Network Part to start from (may be either a pipe or structure), next you will be prompted to select the last connected part at which to terminate setting the slopes. At anytime during the selection process you may enter SE to get to the command settings. In the settings you have the option to set the slope to use, the amount of drop to apply at structures, whether to apply that drop at null structures, which location of the pipes to match, and whether to use a starting elevation and, if so, what that elevation should be. Be sure to use the correct slope, positive if you select the parts going in the upstream direction, or negative if they are selected going downstream.

Adjust Pipe Slopes Settings

See Also

Blue Dot SwapPipeNetworkParts

Swaps multiple pipes or structures from one size to another size.

Blue Dot PipeElevationEditor

Allows editing of pipe invert elevations, ala FeaturelineElevationEditor style.