Description

The ReorderPt command allows the user to renumber points, one at a time or via a Fence selection, starting with a Point Number larger than the highest number currently available in the drawing.

After starting the ReorderPt command, you will be prompted to enter the starting Point Number and the method of point selection, Single or Fence. When in single selecion mode, the Point is immediately updated, when in Fence selection mode, the points will be updated, in the order of selection, at the conclusion of the selection process.

See Also

PackPoints

Renumber points, as needed, to begin at 1 and run consecutvely with no gaps in the numbering.