SincpacC3D General Information Command Summary Quux Software



The PackPoints command renumbers all drawing points, as needed, to begin at 1 and run consecutvely with no gaps in the numbering.

After starting the PackPoints command the Point is immediately updated. All PointGroups that specifically Include and/or Exclude Points by PointNumber are updated to use the new numbers. Exception to the updated PointGroups! Groups that have a Custom Query enabled are not updated and must be done so by the user.

See Also

Blue Dot ReorderPt

Renumber points, one at a time or via a Fence selection, starting with a Point Number larger than the highest number currently available in the drawing.