Description

The PtLocate command allows the user to set a point at the average of measured location from selected points. This command is only available in Sincpac C3D version 3 and newer.

After starting the PtLocate command, you will be prompted to select the points you have measurements from, a mimimum of 3 points are required. Once the selection is complete a settings form will be displayed in which you can change any of the parameters used for setting the point. Options include the point number to use and the general point settings. Enter the measured distance from each point in the Measurement column, when at least 3 measurements have been entered, the calaculated point's Northing and Easting will be displayed, as well as the residual difference from the calculated distance to the new point to the measured distance.

See Also